SQUARE TUBING TRICK AND TIPS | HOW TO BEND BOX BAR AT 90 DEGREE ANGLE

0
Share
Copy the link

33 thoughts on “SQUARE TUBING TRICK AND TIPS | HOW TO BEND BOX BAR AT 90 DEGREE ANGLE

  1. Now thatโ€™s nice and clean looking. Whatโ€™s the thickness of the wall on the square tubing youโ€™re using?

  2. So I got some technical question right here: 1. What grade steel is the tube? 2. What welding stick did you use and what current?

  3. This is standard procedure for me when doing industrial electrical and commercial electrical. Most times we use uni strut but I've used square steel tubing lots of times too. Also do this type of cuts for cable tray as well.

  4. I did this! I'm not a beginner but I'm no pro either. It's possible to do at home in the garage by the average person. Great video ๐Ÿ‘

  5. https://urlgeni.us/youtube/ุงุจุฏุงุน

  6. Thanks for sharing, I'm thinking about making a set of rock sliders for my 4runner and this technique will make it easier.
    Thanks again.

Comments

Your email address will not be published.